Table of Contents
Advertisement
D-Fi™ 2.4 Ghz
The Freedom™ series offers wireless control of two or more products with a single DMX
controller. To automatically set up the D-Fi™ syncing function for DMX functionality, do
(DMX Mode Auto
the following:
Sync)
For the transmitting product:
1.
2.
3.
4.
5.
6.
7.
8.
For the receiving product(s):
1.
2.
3.
4.
5.
6.
7.
8.
Once the steps above are done, press and hold <AUTO> on both the transmitter and
receiver for approximately 20 seconds. The display and signal LED will flash to indicate
sync is activated.
You can then back out to a general menu level and configure the transmitting product to
operate it with a DMX controller.
To configure your product to work with DMX, refer to the
Operation section of this manual.
To add additional products, after syncing each one, turn the synced product off and
repeat the above steps with the new product. Once all products are synced, turn them
all back on.
Auto scan syncing must be done within a distance of about 32 ft (10 m).
If you are experiencing antenna issues or need to improve signal quality, extend the
antenna outward away from the product and keep the line of sight between products
unobstructed.
Ensure that all linked products are configured to the same DMX personality (either 3-
channel or 4-channel).
Caution: D-Fi™ operation can be interrupted or inhibited by liquid masses
between the transmitter and receiver such as water, snow, or people. For best
results, please keep the antenna clear of any liquid mass.
Freedom™ series User Manual (Rev. 06)
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dtA.S appears on the display.
Press <ENTER>.
The display should show dt.AU.
Press <MODE> repeatedly until SYS, ACt, SLAv or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dRA.S appears on the display.
Press <ENTER>.
The display should show dR.AU.
Starting Address
section of the
Page 19 of 28
Advertisement
Table of Contents
