Cable Connection - JVC TK-C685E Instructions Manual

Connection/Installation (TK-C685E/TK-C686E)

Cable Connection

Connecting the alarm input/alarm output
terminals
Alarm input 1/Alarm output 1 terminal
Connecting alarm input 1/alarm output 1 terminal
to external devices such as sensor and buzzer
A Loosen screws on both sides of the terminal block with a
flathead screwdriver and remove the terminal block as
shown in the diagram below.
Memo :
● Inserting the tip of the screwdriver into the slit of the
terminal block will remove the terminal block easily.
B Peel off about 4 mm of the alarm signal cable covering
and insert into the terminal.
C Turn the screws at the side and secure the alarm signal
cable.
D When the alarm signal cable is secured, return the
terminal block that was removed in A to its original
position.
D
C
B
A
Provided alarm cable
Coaxial cable
Power cable
Alarm signal cable
Control signal cable
Alarm signal cable
terminal
A
Alarm Input 2 to 6/Alarm Output 2 Terminal
Pin Cable color
number
1 Brown
2 Red
3 Orange
4 Yellow
5 Green
6 Blue
7 Purple
8 Gray
9 White
10 Black
11 Peach
12 Light green
Provided alarm
cable
Signal Name
Alarm input 2
GND
Alarm input 3
GND
Alarm input 4
GND
Alarm input 5
GND
Alarm input 6
GND
Alarm output 2+
Alarm output 2–