Table of Contents
Advertisement
Connection/Installation (TK-C685E/TK-C686E)
Camera Installation
Procedures
Install the camera with the following procedures.
Preparation (A Page 14)
K
Mounting the ceiling mount bracket (A Page 17)
K
Mounting the camera (A Page 17)
Mounting the Camera
Preparation
Be sure to put on protective glasses to protect your eyes
from falling objects when mounting on the ceiling.
1
Make holes on the ceiling
● Use the provided template to make a hole (R80 mm) for
the connection cables to thread behind the ceiling.
● If necessary, also open a screw hole to mount the
ceiling mount bracket to the ceiling. In this case, align
the D FRONT mark of the template in the direction
where the camera faces front and open the screw hole.
2
Pull the cables from the hole in the ceiling
Pull out the fall prevention wire, power cable, coaxial cable,
control signal cable, alarm signal cable and provided alarm
cable that were mounted to the ceiling slab from the wall.
80 mm
1
Safety wire
Coaxial cable
Alarm signal cable
Power cable
Control signal cable
2
3
Unfasten the ceiling mount bracket from the
camera unit
The ceiling mount bracket comes attached to the camera
unit. Before installing, unfasten the ceiling mount bracket
from the camera unit.
A Check to ensure that the camera fixing lock knobs (x2) is
not turned on.
● If it is locked, slide the camera fixing lock knobs to
unlock in the direction as shown below.
B Push in the camera fixing lock knobs (x2) from both left
and right sides in the direction as illustrated in the
diagram.
● Unfasten the ceiling mount bracket on a table to
prevent it from falling off.
Memo :
● If it is difficult to push in the camera fixing lock knob, push
in while pressing the edge of camera (figure A) against
the table where the process is being carried out.
C Lift the camera unit upward to remove the ceiling mount
bracket, and pull down in the direction as indicated.
A
Camera fixing lock
knob (x2)
B
Ceiling mount bracket
Camera unit
4
Remove the terminal cover
Loosen two screws on the ceiling mount bracket and remove
the terminal cover.
A
B
C
Terminal cover
Hide quick links:
Advertisement
Table of Contents
