Connection/Installation
LAN Cable Connection
Connect the camera to a hub or computer using
a LAN cable.
Cable to use
● Shield (STP) cable
● Make use of a Category 5 (or higher) cable
when 100BASE-TX is used.
When connecting to a hub
Make use of a straight cable.
When connecting to a computer
Make use of a cross cable.
Note :
● However, cross cables cannot be used with
some computer models. When connecting VN-
V686WPU directly to a computer, check the
computer's LAN specifications in advance.
Connecting the alarm signal
cable
Connect the alarm signal cable to external
devices, such as a sensor or buzzer.
Cable to use
● Length of 50 m or shorter
● UL1007, UL1015 or equivalent products
● AWG#22 to AWG#18 or equivalent products
Note :
● Noises from an external source may cause the
RJ-45
conversion
camera to malfunction even when the cable
connector
used is within 50 m. In this case, move the cable
(provided)
away from the noise source.
Solder welding or
crimping
Insulating
tape