JVC TK-C685E Instructions Manual page 27

2
Set the switch (A Page 30, 31)
● Configure the setting switch and machine ID switch
according to the system.
● When installing the heater at an unrequired location, turn
off the switch of the heater.
3
Mount the dome cover to the camera
A Use the screws (x4) to mount the dome cover to the
camera. As a guide, install three claws of the dome
cover and the central mark. Install such that the central
mark appears above the JVC mark of the camera.
Note :
● Check that there is no dirt or dust inside the dome cover
before mounting.
● When installing on a rainy day, ensure that raindrops do
not enter the interior.
● When mounting the dome cover, temporarily secure the 4
screws and then tighten.
● As a guide, tighten the screws to 0.5N•m to 1N•m
(5kgf•cm to 10kgf•cm). If the tightening is loose, the dome
cover may fog due to water seepage.
Heater power switch
Setting Switch
Machine ID switch
Option Switch
Position aligning claws (x3)
The central
mark
(towards direction of the JVC mark)
4
Remove the cable connection cap
Remove the cap on the arm of the camera.
5
Pull out the cables from the cable connection
hole
Pull the cables from the camera unit (except the fall
prevention wire) out from the cable connection hole.
4
Cable connection
cap
5