Operation; Operation 3.0 Operation; Inverter Mode; Figure 3-1, Power Flow - Inverter Mode - Magnum Energy MS-PAE Series Owner's Manual

Operation

3.0 Operation
The MS-PAE Series inverter has two normal operating routines; 1. Inverter Mode, which powers
your loads using the batteries, and 2. Standby Mode, which transfers the incoming AC Power (i.e.
utility power or a generator) to power your loads and uses this incoming power to recharge the
batteries. This inverter also includes an extensive protection circuitry to shut-down the inverter
under certain fault conditions.

3.1 Inverter Mode

When the MS-PAE series is fi rst powered up, it defaults to the OFF mode.
power switch (item 1 fi gure 1-1) must be lightly pressed to turn the inverter ON. Subsequently
pressing this switch alternately turns the inverter OFF and ON.
Inverter OFF - When the inverter is OFF,
loads and the status
is connected and qualifi ed on the inverter's AC input, this AC input power will pass through the
inverter to power the AC loads. However, if this AC power is lost, the AC loads will no longer be
powered because the inverter is OFF.
When the inverter is turned ON, it operates either by "Searching" or "Inverting", depending on
the connected AC loads.
Searching - When the inverter is fi rst turned ON, the automatic Search feature is enabled. This
feature is provided to conserve battery power when AC power is not required. In this mode, the
inverter pulses the AC output looking for an AC load (i.e. electrical appliance). Whenever an AC load
(greater than 5 watts) is turned on, the inverter recognizes the need for power and automatically
starts inverting. When there is no load (or less than 5 watts) detected, the inverter automatically
goes back into search mode to minimize energy consumption from the battery bank. When the
inverter is "Searching", the inverter's green LED fl ashes (fast).
Info: The factory default value for the Search feature is 5 watts, it can be turned off
or adjusted from 5 to 50 watts using the ME-RC or ME-ARC remote display.
Inverting - When a load greater than 5 watts is connected to the inverter output, the MS-PAE
series "inverts" the DC power from the battery and supplies 120/240VAC power to your sub-panel
The inverter's green LED fl ashes once every 2 seconds (medium fl ash) to indicate it is inverting.
The amount of time the inverter can be inverting and
amount of AC loads that are connected and the capacity of the battery bank. Refer to fi gure 3-1
to see the fl ow of power from the DC input to the AC output while in the Inverter Mode.
AC H OT 1 IN
AC H OT 2 IN
AC N EU T R AL
D C
D C N EGAT IVE
IN
D C POSIT IVE

Figure 3-1, Power Flow - Inverter Mode

Page 28
LED will be OFF. If AC power from an external source (Utility or Generator)
AC T ransfer R elay
C B 3 (30 A )
C B 2 (30 A )
AC
D C
F ET Bridge
no power is used from the batteries to power the AC
provide power is directly related to the
Pow er T ransform er
The momentary ON/OFF
AC
OU T
240
AC H OT 1 OU T
VA C
120
VAC
120
AC H OT 2 OU T
VAC
AC N EU T R AL
© 2009 Magnum Energy Inc