Multitech MultiModem MT5600ZDX User Manual page 41

4 AT Commands, S-Registers, and Result Codes
Command:
*B View Numbers in Blacklist
Values: n/a
If blacklisting is in effect, %B displays the numbers for which
Description:
the last call attempted in the previous two hours failed. In
countries that do not require blacklisting, the ERROR result
code is displayed.
Command: *D View Delayed Numbers
Values: n/a
This command displays a list of delayed numbers as defined in
Description:
the *B command together with their delay times. If no
numbers are delayed, only the OK result code is displayed.
Command: #CID= n Caller ID
n = 0, 1, or 2
Values:
Default: 0
Description: Enables or disables Caller ID recognition and reporting.
#CID=0 Disables Caller ID.
#CID=1 Enables formatted Caller ID reporting of ICLID SDM (Single
Data Message) and MDM (Multiple Data Message) packets.
#CID=2 Enables unformatted Caller ID reporting of any ICLID packet
received after the first RING cycle, including SDM, MDM, or
call waiting packets.
#CID? Retrieves the current Caller ID mode from the modem.
#CID=? Returns the mode capabilities of the modem in a list with each
element separated by commas.
Command: @M n MNP10 Initial Cellular Power Level Setting
Values: n = 0–30
Default: n/a
Description: This command is included only for compatibility and performs
no function.
@M0–@M30 n/a
Command: )M n Enable MNP10 Cellular Power Level Adjustment
Values: n = 0, 1, or 2
Default: n/a
Description: This command is included only for compatibility and performs
no function.
)M0–)M2 n/a
Command: *H n MNP10 Link Negotiation Speed
Values: n = 0, 1, or 2
Default: n/a
Description: This command is included only for compatibility and performs
no function.
)H0–)H2 n/a
37