Multitech MultiModem MT5600ZDX User Manual page 37

4 AT Commands, S-Registers, and Result Codes
Data mode. The modem receives the break from the remote
modem during a non-error-corrected connection:
\K0 Clear data buffers and send break to the computer.
\K1 Same as \K0.
\K2 Send break immediately to the computer.
\K3 Same as \K2.
\K4 Send break to the computer in sequence with the received data.
\K5 Same as \K4.
Online command mode. The modem receives a \Bn command
from the computer:
\K0 Clear data buffers and send break to the remote modem.
\K1 Same as \K0.
\K2 Send break immediately to the remote modem.
\K3 Same as \K2.
\K4 Send break to the remote modem in sequence with the
transmitted data.
\K5 Same as \K4.
Command: \N n
Error Correction Mode Selection
Values: n = 0–5
Default: 3
Description: \N0 Normal (non-error correction) mode with data buffering. Same
as &Q6.
\N1 Direct mode.
\N2 V.42/MNP reliable (error-correction) mode; failure to make a
reliable connection causes the modem to hang up.
\N3 Similar to N2, but failure to make reliable connection causes
the modem to fall back to normal mode.
\N4 V.42 (LAPM) reliable mode; failure to make an LAPM
connection causes the modem to hang up.
\N5 MNP reliable mode; in the MNP error correction mode, failure
to make a reliable connection causes the modem to hang up.
Command: \V n Single Line Connect Message
n = 0 or 1
Values:
Default: 0
Description: \V0 Disables single line connect message. Connect messages are
controlled by the X, W, and S95 settings.
\V1 Enables single line connect messages in the format: CONNECT
<Serial Port Speed></Modulation></Protocol></Compression>
</Line Speed>/<Voice and Data>. Connect messages are
displayed in the single line format subject to the commands V
and Q. In non-verbose mode (V0), single line connect messages
are disabled and a single numeric result code is generated for
CONNECT.
Note: The effect of Wn is disabled when\V1 is set.
33