Multitech MultiModem MT5600ZDX User Manual page 34

4 AT Commands, S-Registers, and Result Codes
Command: &V Display Current Configuration
Values: 0
Default: None
Description: Displays the current (active) settings. Example of an active
profile:
B1 E1 L1 M1 N1 Q0 T V1 W0 X4 Y0 &C1 &D2 &G2 &J0 &K3 &Q5 &R1 &S0 &T5 &X0 &Y0
S00:001 S01:000 S02:043 S03:013 S04:010 S05:008 S06:003 S07:055 S08:002 S09:006
S10:014 S11:095 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020 S46:138
S48:007 S95:000
Command: &V1 Display Last Connection Statistics
Values: 1
Default: None
Displays the statistics for the last connection. Example of last
Description:
connnection statistics:
Note: Not available in all versions.
Command: &W n Store Current Configuration
n = 0 or 1
Values:
Default: None
Description: &W0 Stores current modem settings in nonvolatile memory as Profile 0.
Profile 0 is loaded instead of the factory defaults at power-on
(if &Y0 is set) and by the ATZ command.
&W1 Stores current modem settings in nonvolatile memory as Profile 1.
Profile 1 is loaded instead of the factory defaults at power-on
(if &Y1 is set) and by the ATZ1 command.
Note: See also the Z, &F, and &Y commands.
TERMINATION REASON...... LOCAL REQUEST
LAST TX rate.................
HIGHEST TX rate..............
LAST RX rate.................
HIGHEST RX rate..............
PROTOCOL.....................
COMPRESSION.................. V42Bis
Line QUALITY.................
Rx LEVEL.....................
Highest Rx State .............
Highest TX State.............
EQM Sum......................
RBS Pattern..................
Rate Drop....................
Digital Loss.................
Local Rtrn Count.............
Remote Rtrn Count............
V90
21600 BPS
21600 BPS
45333 BPS
45333 BPS
LAPM
031
015
67
67
00D3
00
00
3F07
00
00
30