Table of Contents
Advertisement
USERS IN CANADA
PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE EQUIPMENT
A. Location
Supply a suitable table, cabinet, or desk. See Appendix B for the unit's dimensions
and weight.
B. Order Information
1. Provide only a single-line to touch-tone or rotary telephone set terminated with
a standard 4-pin modular phone plug. <Touch-tone is recommended if available
in your area.)
2. Order an RJ 11-C modular jack (USOC code), which should be installed by the
phone company. If the RJ11-C jack is not present, installation cannot occur.
3. Order a normal business line from your telephone company's business
representative. The line should be a regular voice grade line or equivalent. Use
one line per unit.
DDD (DIRECT DISTANCE DIAL) LINE
or
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE
OVERSEAS
Note
Canon recommends an individual line following industry standards [e.g., the 2500
(touch tone) or 500 (rotary/pulse dial) telephonesl. A dedicated extension off a PBX
unit without "Camp On" signals is also permissible with a fax unit. Key telephone
systems are not recommended because they send non-standard signals to
individual telephones for ringing and special codes, which may cause a fax error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or Duplex).
It should be independent from copiers, heaters, air conditioners, or any electric
equipment that is thermostatically controlled. The rated value is 120 volts and 15
amperes. The RJ11-C modular jack should be relatively close to the power outlet to
facilitate installation.
NOTICE
The Industry Canada label identifies certified equipment. This certification means that
the equipment meets certain telecommunications networks protective, operational
and safety requirements. The Department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. In some cases, the
company's inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
The Load Number (LN) assigned to each terminal device denotes the percentage of the
total load to be connected to a telephone loop which is used by the device, to prevent
overloading. The termination on a loop may consist of any combination of devices
subject only to the requirements that the total of the Load Numbers of all the devices
does not exceed 100.
!
I
II
1
-------v·~J
Canon CFX-l4000 User's Guide
~
Advertisement
Table of Contents
