Table of Contents
Advertisement
USERS IN U.S.A.
PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE EQUIPMENT
A. Location
Supply a suitable table, cabinet. or desk. See Appendix B for the unit's dimensions
and weight.
B. Order Information
1.
Only a single line, touch tone or rotary telephone set is to be used.
2.
Order an RJ11-C modular jack (USOC code), which should be installed by the
phone company. If the RJ 11
~C
jack is not present; installation can not occur.
3.
Order a normal business line from your telephone company's business
representative. The line should be a regular voice grade line or equivalent. Use
one line per unit.
DOD (DIRECT DISTANCE DIAL) LINE
or
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE
OVERSEAS
Note
Canon recommends an individual line following industry standards le.g., the 2500
(touch tone) or 500 (rotary/pulse dial) telephones). A dedicated extension off a PBX
unit without "Call Waiting" can be used with your fax unit. Key telephone systems
are not recommended because they send non-standard signals to individual
telephones for ringing and special codes, which may cause a fax error.
C. Power Requirements
This equipment should be connected to a standard 120 volt AC, three-wire
grounded outlet only. Do not connect this unit to an outlet or power line shared
with other appliances that cause "electrical noise." Air conditioners, electric
typewriters, copiers, and machines of this sort generate noise which often inter-
feres with communications equipment and the sending and receiving of docu-
ments.
CONNECTION OF THE EQUIPMENT
This equipment complies with Part 68 of the FCC rules. On the rear panel of this
equipment is a label that contains, among other information, the FCC Registration
Number and Ringer Equivalence Number (REN) for this equipment. If requested, this
information must be given to the telephone company. This equipment may not be
used on coin service provided by the telephone company. Connection to party lines is
subject to state tariffs.
IN CASE OF EQUIPMENT MALFUNCTION
Should any malfunction occur which cannot be corrected by the procedures described
in this Use'" Guide disconnect the equipment from the telephone line or unplug the
power cor.d. The telephone line should not be reconnected or the power cord plugged
in until the problem is completely resolved. Users should contact their local authorized
Canon Facsimile Dealer for servicing of equipment.
d!
!;
1: .
-C-a-no-n-C-FX--l-4-00-0-U-s-e-r's-G-u-id-e----------------------------------=-il,,'
Advertisement
Table of Contents
