Table of Contents
Advertisement
CONTROLS. COMPONENTS. AND CONNECTIONS
,Powering Up
V
If you are planning on increasing your fax's memory. see Appendix C
Note
before you power up.
Once you finish setting up your fax, you are ready to power it up.
A
Warning
A
Caution
Note
Getting Started
Follow these guidelines when connecting your fax to a power source:
•
The fax unit is intended for do'mestic use only and requires 120
V AC. Do not use it outside the country where you purchased it.
•
Use only the power cord that came with the unit. Using a
longer cord or extension cord can cause the fax to malfunction.
•
Unplug the unit by pulling on the plug itseU. not on the cord.
•
Do not plug the fax into a power outlet shared with an appli-
ance that generates electrical noise, such as an air conditioner,
computer, electric typewriter. or copier.
•
Make sure nothing is laying on the power cord, and that the
cord is located where it cannot be walked on or tripped over.
•
Do not overload the electrical outlet. Make sure that the total
amperage used by all products plugged into the wall outlet
does not exceed the ampere rating of the outlet's circuit
breaker.
To connect the power cord, plug the cord into the power receptacle
on the fax. and then into a properly grounded, three-prong 120 V AC
outlet.
Before plugging in the fax. make sure there are no documents in the
automa~ic
document feeder (ADF).
• The fax has no power switch, so its power is on as soon as you
plug it in. Once powered up, though. the unit still needs to warm
up before you can use it.
• Depending on the number of pages accumulated in the fax
memory, it can take up to four minutes for the unit to warm up.
2..15
•
Advertisement
Table of Contents
