3C-4. Edit Scene - Korg D32XD Owner's Manual

2
3
1. Set View
Press this button to open the Set View dialog box. Press
the OK button to apply your selections, or press the Can-
cel button to cancel them.
1a. Event View Source
Press a radio button to choose the parameter that will
appear in the event view.
1b. Time Resolution/dot
Specify the range that will appear in the event view.
The range shown will be the time you specify here
192.
1a
2. Event view
This area shows the events of the source you selected in
Set View.
3. Event list
Displays the events selected in the "9. Select List." To edit
an event, select (highlight) it by pressing it in the list.
4. Edit
Press this button to open the Edit Event dialog box.
4b
4a. Event select button
Use this to select the event you want to edit. Press this
button and use the value dial (or +/– keys) to make
your choice.
4b. Parameter/Parameter value [MIDI value]/Location
Select (highlight) the parameter or location that you
want to edit, and use the value dial (or +/– keys) to
edit it.
The only way to edit a scene is to change its location.
The values will not be updated until you press the OK
button to confirm your edits.
5. Cut
1
4
5
6
7
8
6. Copy
9
7. Paste
[0.05, 0.1, 0.2, 0.5, 1sec]
8. Undo
9. Select List
1b
4a

3c-4. Edit Scene

The mixer settings you adjust can be stored as a "scene" at a
desired location, and automatically recalled during playback
to change the mixer settings (when the "3c-2. Automation"
setting "Automation" is on). You can also recall a scene
when desired as a set of general-purpose settings ( p.52).
You can store one hundred scenes for each song.
A scene may contain the following settings.
Channel parameters
Effects
Press this button to open the Cut Event dialog box.
The selected event will be cut (deleted) from the event
list. However, the event itself will be temporarily saved
in the edit buffer (clipboard).
To execute the cut, press the Yes button. To cancel, press
the No button.
To cut all events in the event list, press (highlight) the
Select All button and then execute Cut.
Press this button to open the Copy Event dialog box.
The selected event will be copied temporarily to the edit
buffer (clipboard).
To execute the copy, press the Yes button. To cancel, press
the No button.
To copy all events in the event list, press (highlight) the
Select All button and then execute Copy.
Press this button to open the Paste Event dialog box. The
event temporarily saved in the edit buffer (clipboard) will
be pasted following the selected event.
To execute the paste, press the Yes button. To cancel,
press the No button.
Press this button to return to the state prior to executing
Cut, Copy, or Paste. This can be used only to return to the
immediately previous state. If the button indicates Redo,
you can use it to cancel the Undo.
The data is held in common with the "7. Undo" data of "3c-2.
Automation." If you press the Automation Undo button
immediately after event-editing, the last event-edit will be
undone – not the automation recording.
Press this button to open the Select List dialog box. Here
you can select the channel and parameter that will be dis-
played in the event list. You can select one (and only one)
of channels 1–32, Master Fader, or Expression.
CH ON, PlayEQ, ATT, sends, insert effect assignments,
fader, pan
Effect program numbers and Trim of the insert, master,
and final effects.
105