Korg D32XD Owner's Manual page 24

6 MIDI OUT connector
MIDI messages are transmitted from this connector. Use this when you wish to
use the D32XD/D16XD to control an external device via MIDI. ( p.93, 131)
7 MIDI IN connector
MIDI messages are received at this connector. Use this when you wish to con-
trol the D32XD/D16XD from an external MIDI device. ( p.93, 131)
8 S/P DIF OUT jack
This is an optical-type S/P DIF format (IEC60958, EIAJ CP-1201) digital out-
put jack (stereo).
Use an optical cable to connect this jack to the optical digital input of your
DAT, MD or other equipment.
This output provides the same audio as the MASTER OUT L/R jacks, but as a
digital signal at the same sampling frequency and bit depth as the current song.
9 S/P DIF IN jack
This is an optical-type S/P DIF format (IEC60958, EIAJ CP-1201) digital input
jack (stereo).
Use an optical cable to connect this jack to the optical digital output of your
DAT, MD or other equipment.
This input provides a digital audio signal at the same sampling frequency and
bit depth as the current song.
10 Phantom power switch
INPUT 1–8 jacks provide +48V phantom power so that condenser mics can be
used. Phantom power is supplied to the balanced XLR jacks, and can be
selected independently for each channel. Turn this switch on only for chan-
nels that use a condenser mic.
If a condenser mic is connected or disconnected with the phantom power switch on, damage
to your equipment may occur. For this reason, always turn the phantom power switch off
before connecting or disconnecting a condenser mic.
If the phantom power switch is on, you must never connect any device other than a con-
denser mic. Doing so may damage your equipment.
11 AUX OUT 1, 2, 3, 4 [*AUX OUT 1, 2] jacks
These jacks output the external send audio signals from the mixer channels
( p.47, 112). You can connect these to the input jacks of an external effect
processor.
These are 1/4" unbalanced phone jack outputs.
12 MONITOR OUT L/R jacks
Connect these jacks to your external monitor system. In MIXER, SOLO/
MONITOR, "Monitor" tab page ( p.50, 114) you can select the bus that will
be monitored from these outputs. These jacks output the same audio as the
PHONES jacks.
These are 1/4" balanced/unbalanced TRS phone jack outputs.
13 MASTER OUT L/R jacks
These jacks provide the analog audio signal from the master bus, or the audio
signals selected by the SOLO function. You can select the solo source in
MIXER, SOLO/MONITOR, "Solo" tab page.
Connect these jacks to your external monitor system or recording device.
These jacks provide an analog version of the audio being sent to the S/P DIF
OUT jack.
These are 1/4" balanced/unbalanced TRS phone jack outputs.
14