Replacing The Hard Drive Assembly; Removing The Single-Drive Assembly; Figure 5-5 Installing The Power Supply - Fujitsu SPARC Enterprise T1000 Service Manual

FIGURE 5-5
4. Redress the power cable through the midwall in the chassis and connect the cable
to the motherboard.
5. Perform the procedures described in
6. At the sc> prompt, issue the showenvironment command to verify the status of
the power supply.
5.4

Replacing the Hard Drive Assembly

5.4.1

Removing the Single-Drive Assembly

1. Disconnect the drive cable from the data/power connector at the rear of the hard
drive (
2. Pull the fasteners up on the rear of the single-drive assembly, and remove the
single-drive assembly from the chassis (
Fastener
Installing the Power Supply
).
FIGURE 5-6
Chapter 6.
).
FIGURE 5-6
Chapter 5 Replacing Field-Replaceable Units
Power supply
5-7