Figure 5-9 Removing The Single-Drive Assembly - Fujitsu SPARC Enterprise T1000 Service Manual

2. Disconnect the drive cable from the data/power connector at the rear of the hard
drive (
3. Pull the fasteners up on the rear of the single-drive assembly and remove the
assembly from the chassis (
FIGURE 5-9
5.5.1.2 Installing the Hard Drive in a Single-Drive Assembly
1. Unpack the replacement single-drive assembly.
2. Slide the single-drive assembly into the chassis until it mates with the front of the
chassis (
).
FIGURE 5-9
Removing the Single-Drive Assembly
).
FIGURE 5-10
).
FIGURE 5-9
Chapter 5 Replacing Field-Replaceable Units 5-13