Finishing Up Servicing; Final Service Procedures; Replacing The Top Cover; Reinstalling The Server Chassis In The Rack - Fujitsu SPARC Enterprise T1000 Service Manual

6
C H A P T E R

Finishing Up Servicing

This chapter describes how to finish up servicing the server.
The following topics are covered:
Section 6.1.1, "Replacing the Top Cover" on page 6-1
■
Section 6.1.2, "Reinstalling the Server Chassis in the Rack" on page 6-1
■
Section 6.1.3, "Applying Power to the Server" on page 6-2
■
6.1

Final Service Procedures

This section provides the finishing tasks in servicing your server.
6.1.1

Replacing the Top Cover

1. Place the top cover on the chassis.
Set the cover down so that the cover hangs over the rear of the server by about an
inch (2.5 cm).
2. Slide the cover forward until it latches into place.
6.1.2

Reinstalling the Server Chassis in the Rack

1. Refer to the SPARC Enterprise T1000 Server Installation Guide for installation
instructions.
2. After you have reinstalled the server chassis in the rack, reconnect all cables that
you disconnected when you removed the chassis from the rack.
6-1