Table of Contents
Advertisement
Single Address: The IP address of the local host.
Subnet: The subnet of the local network. For example, IP: 192.168.1.0 with Netmask
255.255.255.0
192.168.1.1 through to 192.168.1.254).
Remote Secure Gateway: The IP address of the remote VPN device that is connected and
establishes a VPN tunnel.
Anonymous: Enable any IP to connect in
Remote Network: Set the IP address or subnet of the remote network.
Single Address: The IP address of the remote host.
Subnet: The subnet of the remote network. For example, IP: 192.168.1.0 with Netmask
255.255.255.0
192.168.1.1 through to 192.168.1.254).
If remote peer supports multiple local subnets, you can click
Key Exchange Method: Displays key exchange method.
Pre-Shared Key: This is for the Internet Key Exchange (IKE) protocol, a string from 4 to 128
characters. Both sides should use the same key. IKE is used to establish a shared security policy
and authenticated keys for services (such as IPSec) that require a key. Before any IPSec traffic
can be passed, each router must be able to verify the identity of its peer. This can be done by
manually entering the pre-shared key into both sides (router or hosts).
Local ID Type and Remote ID Type: when the mode of phase 1 is aggressive, local and
Remote ports can be identified by other IDs.
ID content: Enter ID content the name you want to identify when the Local and Remote Type are
Domain Name; Enter ID content the email address you want to identify when the Local and
Remote type are Email; Enter ID content IPv4 address you want to identify when the Local and
Remote Type are IPv4 address.
Phase 1
Mode: Select IKE mode from the drop-down menu: Main or Aggressive. This IKE provides
secured key generation and key management.
Encryption Algorithm: Select the encryption algorithm from the drop-down menu. There are
several options: DES, 3DES and AES (128, 192 and 256). 3DES and AES are more powerful but
increase latency.
DES: Stands for Data Encryption Standard, it uses 56 bits as an encryption method.
3DES: Stands for Triple Data Encryption Standard, it uses 168 (56*3) bits as an
encryption method.
specifies
one
class
specifies
one
class
C
subnet
starting
C
subnet
starting
to enter more subnets.
132
from
192.168.1.1
from
192.168.1.1
(i.e.
(i.e.
Advertisement
Table of Contents
