Toyota Sienna 2007 Operating Manual page 90

When you install the second seats, be
sure to place it where the seat is origi-
nally positioned because each second
seat is not interchangeable. You can
distinguish the original seat position by
the position of the front seat leg pin
and the shape of the seat striker bezel
in the floor.
The right side second seat has a pin in
the outside of the right front leg and the
left side second seat has a pin in the
outside of the left front leg as shown in
the illustration.
CAUTION
You must install the seat in proper
position to wear the seat belt proper-
ly. Failure to be properly restrained
with the seat belt in an accident can
cause death or serious injury. Refer
to the label on the side of the seat
for additional installation instructions.
NOTICE
You must install the seat in its origi-
nal position. If it is installed in the
wrong position, the seat lock or bezel
will be damaged.
07 SIENNA_U (L/O 0612)
1. Align the front leg hooks with the
rear strikers in the floor. Then swing
up the seat.
2. Make sure the front leg is locked
securely, fold down the seat and en-
gage the rear leg lock.
2007 SIENNA from Oct. '06 Prod. (OM45437U)
81