Toyota Sienna 2007 Operating Manual page 246

D
Do not use the conventional mode
in the following conditions, or seri-
ous injury or death could result:
To help maintain maximum control
of your vehicle, do not use conven-
tional cruise control mode when us-
ing dynamic laser cruise control
while driving in heavy or varying
traffic, or on slippery (rainy, icy or
snow−covered) or winding roads.
Be careful about vehicle speed as
it may increase when driving down-
hill with the conventional cruise
control mode selected.
07 SIENNA_U (L/O 0612)
TURNING THE SYSTEM ON AND OFF
To turn the conventional cruise control
mode on, turn the "ON−OFF" button on.
The "CRUISE" and "READY"
lights on the instrument panel will come
on. Push the lever in the "MODE" direc-
tion for longer than 1 second to change
to conventional cruise control mode. The
indicator on the instrument panel is as
shown. You can now set the cruising
speed. Pressing the "ON−OFF"
again turns the system off.
When the system is turned off, cruising
speed must be reset when the convention-
al cruise control mode is turned on again.
However, once the vehicle−to−vehicle dis-
tance control mode activates and is used,
it cannot be changed to the conventional
cruise control mode using the above op-
eration. To change the mode, press the
"ON−OFF" button to turn the system off
and then press it again to turn it on. Next
push the lever in the "MODE" direction for
longer than about 1 second.
To change to the vehicle−to−vehicle dis-
tance control mode from the conventional
cruise control mode, push the lever in the
"MODE" direction for longer than about 1
second.
CAUTION
indicator To avoid accidentally engaging the
cruise control, turn the system off
when it is not in use. Make sure the
"CRUISE" indicator light is off.
button
2007 SIENNA from Oct. '06 Prod. (OM45437U)
237