Toyota Sienna 2007 Operating Manual page 110

CAUTION
When folding or returning the seats,
observe the following precautions in
order to prevent personal injury:
D
Make sure that the seat path is
clear before moving the seat. Other-
wise, injury may result from contact
with the seat.
D
Be careful not to allow hands or
feet to get caught or pinched in the
seat.
When returning the seats to their
original position, make sure the seat
belts are not twisted or caught in the
seatback. It could result in serious
injuries in a sudden braking or a col-
lision.
Do not shift the automatic transmis-
sion selector lever out of "P" with
the ignition key in "ON" during the
operation. Doing so may cause the
vehicle to move and result in serious
personal injury.
07 SIENNA_U (L/O 0612)
This "3RD SEAT" warning light warns the
third seat operation is not yet complete
when the ignition key is turned to the
"ON" position.
—Stowing third seat
(power seat)
The third seats can be stowed by push-
ing and holding the stowing switch that
is inside the back door opening on the
outer edge of the ceiling.
Before stowing the third seats:
D
Stow the seat belt buckles and center
seat belt. (See "—Stowing seat belt
buckles of the second and third seats"
on page 114 and "—Stowing the center
seat belt of the third seats" on page 114
in this Section.)
D
Lower the head restraint to the lowest
position. (See "Head restraints"
page 106 in this Section.)
D
Make sure that there is no object on
the seat cushion, floor around
seats and floor of the luggage compart-
ment. If an object is caught during the
operation, seat operation will stop.
2007 SIENNA from Oct. '06 Prod. (OM45437U)
on
the
101