Toyota Sienna 2007 Operating Manual page 209

If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road conditions. If the light comes on,
replace it as soon as possible.
The system must be reset after the en-
gine oil replacement. Reset the system by
the following procedure:
1. Turn the ignition key to the "ACC" or
"LOCK" position with the odometer
reading shown. (For details,
"Odometer and two trip meters" on
page 190 in this Section.)
2. Turn the ignition key to the "ON" posi-
tion while holding down the trip meter
reset button.
Hold down the button for at least 5 sec-
onds. The odometer indicates "000000"
and the light goes off.
If the system fails to reset, the light will
continue flashing.
200
07 SIENNA_U (L/O 0612)
(o) Third Seats Warning
Buzzer
"3RD SEAT" Warning light (instrument
cluster)—
This light warns that the third seat opera-
tion is not yet complete. Complete the
third seat operation. For
"—Folding third seats" on page 98 or
"—Stowing third seats" on page 101 in
Section 1−3.
see
Third seats warning light and buzzer
(switch)—
This light warns that the third seat opera-
tion is not yet completed.
When flashing—An object may be caught
between the seat and seatback.
When illuminated—An object
caught between the seat and floor or
switch is released during the operation.
Remove the object and
again. If nothing is caught when flashing,
contact your Toyota dealer.
Light and (p) Dynamic Laser Cruise Control Mas-
ter Warning Light
This light warns that there is a problem
somewhere in the dynamic laser cruise
control system.
The light will come on when the ignition
details, see key is turned to "ON" and go off after a
few seconds.
When the light
sounds and the warning code will appear
on the display. At this time, dynamic laser
cruise control is cancelled. For details,
see "Dynamic laser cruise control" on
page 224 in Section 1−7.
(q) Key Reminder Buzzer
This buzzer acts as a reminder to remove
the key when you open the driver's door
may be
with the ignition key in the "ACC" or
"LOCK" position.
then operate
2007 SIENNA from Oct. '06 Prod. (OM45437U)
comes on, the alarm