Toyota Sienna 2007 Operating Manual page 40

Center pillar
OPERATING WITH THE POWER SLIDING
DOOR SWITCHES
To open the door, push the switch. To
close the door, push the switch once
again. The door opens and closes com-
pletely.
Switches on the front overhead con-
sole:
" " switch—To operate the left side
door (type B only)
" " switch—To operate the right side
door
07 SIENNA_U (L/O 0612)
Switches on the center pillar:
"PWR DOOR" switch—To operate each
side door
Opening operation can be performed by
the switches under the following condi-
tions:
D
The sliding door is unlocked.
D
The power sliding door system is on.
(The "SLIDE DOOR OFF" switch is
pushed out.)
D
The sliding door is between the fully−
closed position and half−opened posi-
tion.
D
When the ignition key is in the "ON"
position, the transmission selector lever
must be in "P".
D
The child−protector is unlocked.
(switches on the center pillar only)
Closing operation can be performed by
the switches under the following condi-
tions:
D
The power sliding door system is on.
(The "SLIDE DOOR OFF" switch is
pushed out.)
D
The sliding door is between the fully−
opened position and half−opened posi-
tion.
Left and right side power sliding door
models—The left side power sliding door
does not operate when the fuel filler door
is opened.
The length of time required to push the
switches for operating the sliding door can
be changed. For details, contact your
Toyota dealer.
CAUTION
If you shift the automatic transmis-
sion selector lever out of "P" and
accelerate before the power sliding
door is closed completely, the sliding
door may reverse to the open posi-
tion. A child or others could fall out
of the vehicle and be injured. Always
make sure the power sliding door is
closed and latched before you start
driving.
2007 SIENNA from Oct. '06 Prod. (OM45437U)
31