Toyota Sienna 2007 Operating Manual page 112

STOWING THIRD SEATS
Push and hold the stowing switch. A
beep sounds twice to indicate the start
of the operation. The beep sounds
again twice when the operation is com-
pleted.
If the indicator light above the switches
flashes while the stowing switch is being
pushed, the stowing operation will not
start.
07 SIENNA_U (L/O 0612)
To continue the operation, do the follow-
ing:
1. Open the back door when the ignition
key is in "LOCK" or "ACC" and/or the
automatic transmission selector lever is
in "P".
2. Push and hold the stowing switch.
To operation stops, the indicator
above the switches comes on and a beep
sounds for about 10 seconds if any of the
following condition occur during the opera-
tion:
D
When the stowing switch is released.
D
When the folding/returning switch, re-
turning switch or seatback adjusting
switch is pushed while the stowing
switch is being pushed.
D
When the ignition key is turned to the
"ON" position and the automatic trans-
mission selector lever is moved from
the "P" position.
D
When the automatic transmission selec-
tor lever is in the "N" position and the
ignition key is turned to the "ON" posi-
tion.
If the engine is started during operating,
the seat operation may also be stopped.
If an object is caught between the seat-
back and seat cushion, the indicator
light above the switches flashes and a
beep sounds for about 10 seconds. Re-
move the object before operating the
seat again.
If the indicator light above the switches
flashes even though there is no object
light
between the seatback and seat cushion,
contact your Toyota dealer.
If an object is caught between the seat
and floor, the object prevents the seat
from moving. Do not continue the op-
eration. Remove the object before oper-
ating the seat again.
When the seat is already folded, the seat
can be stowed using the same procedure.
If an object is caught between the seat-
back and seat cushion, the stowing opera-
tion will not start.
2007 SIENNA from Oct. '06 Prod. (OM45437U)
103