Toyota Sienna 2007 Operating Manual page 227

D
If the ID code on the tire pressure
warning valves and transmitters is not
registered in the tire pressure warning
ECU.
D
If electronic devices or facilities using
similar radio wave frequencies
nearby.
D
If a radio set at similar frequencies is
in use in the vehicle.
D
If a window tint that affects the radio
wave signals is installed.
D
If there is a lot of snow or ice on the
vehicle, in particular around the wheels
or wheel housings.
D
If non−genuine Toyota wheels are used.
D
If tire chains are used.
If the tire pressure warning light continues
to come on after blinking for 1 minute
when the ignition key is turned to the
"ON" position, have the system checked
by your Toyota dealer.
Even if you use genuine wheels, the tire
pressure warning system may not work
properly with some types of tires.
218
07 SIENNA_U (L/O 0612)
Pushing the tire pressure warning reset
switch should not turn off the tire pressure
warning light.
For vehicles sold in U.S.A.
are
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including
that may cause undesired operation.
NOTICE:
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protec-
tion against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed
interference
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. However, there is
no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interfer-
ence to radio or television reception,
which can be determined by turning the
equipment off and on, the user is en-
couraged to try to correct the interfer-
ence by one or more of the following
measures:
−Reorient or relocate the receiving an-
tenna.
−Increase the separation between the
equipment and receiver.
2007 SIENNA from Oct. '06 Prod. (OM45437U)