Toyota Sienna 2007 Operating Manual page 75

SETTING THE DRIVING POSITION
The key must be in the "ON" position and
the selector lever is in the "P" position.
1. Adjust the driver's seat and outside
rear view mirrors to the desired
position.
2. While pushing the "SET"
push button "1" or "2" until a beep
is heard.
The system can memorize up to 2 posi-
tions by repeating the above steps. If step
2 is performed when both buttons "1" and
"2" are memorized, the previous position
will be erased and a new position will be
set.
66
To make only slight changes to an already
memorized position, the easiest way is to
first activate the memorized position, then
make the desired changes and perform
step 2 above.
button,
07 SIENNA_U (L/O 0612)
RECALLING THE MEMORIZED POSITION
When you push button "1" or "2", a
beep will sound and the driving posi-
tion will be automatically adjusted to
the position recorded for that button.
The memorized position can be recalled
under the following conditions:
D
The ignition key is in the "ON position
and the selector lever is in the "P"
position.
D
The key is not in the ignition switch
and less than 30 seconds have passed
since opening the driver's door.
2007 SIENNA from Oct. '06 Prod. (OM45437U)