Problems With Nec Expressbuilder - NEC N8100-1429F User Manual

Problems with NEC EXPRESSBUILDER

When the server is not booted from the NEC EXPRESSBUILDER DVD, check the following:
Did you set the NEC EXPRESSBUILDER during POST and restart the server?
→ If you do not set the NEC EXPRESSBUILDER during POST and restart the
server, an error message will appear or the OS will boot.
Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS SETUP utility of the server.
Use the BIOS SETUP utility to change the boot device order to boot the system
from the optical disk drive first.
<Menu to check: [Boot]>
If [Os installation ***default***] is selected at Boot selection screen, following
message is displayed.
After this message appears, check the error and take the appropriate corrective action
according to the message listed in the table below.
Message
This EXPRESSBUILDER version was not
designed for this computer.
Insert the correct version and click [OK]. (When
you click [OK], the computer reboots.)
EXPRESSBUILDER could not get the hardware
parameters written in this motherboard.
This version is not designed for this computer or
the motherboard may be broken. (When you click
[OK], the computer reboots.)
The hardware parameters written in this
motherboard are incorrect.
This version is not designed for this computer or
the motherboard may be broken.
Troubleshooting 8-29
Cause
This NEC EXPRESSBUILDER
version is not designed for this server.
Execute the NEC EXPRESSBUILDER
on the compliant server.
This message is shown when NEC
EXPRESSBUILDER could not find
system-specific information because
of mother board exchange and so on.