NEC N8100-1429F User Manual page 109

Boot
If you move the cursor to the position of "Boot," the Boot menu appears, which is used to set the
boot priority.
Indication
USB CDROM
IDE CD
USB FDC
USB KEY
IDE HDD
PCI SCSI
PCI BEV
1.
When BIOS detects a bootable device, it displays the information on the device in the
relevant indication.
To boot the server from a desired device, the device must be registered as a boot device.
(Up to eight boot devices can be registered.)
2.
Pressing X after selecting a device allows the selected device to be registered as a boot
device or deleted from the registration.
With eight boot devices being registered, any other device cannot be registered as a boot
device even if you press X. To register a device as a boot device newly, first delete the
registration of a device registered as a boot device but not booted any more.
Pressing Shift + 1 after selecting a device allows the selected device to be made
enabled/disabled.
3.
You can change the boot priority (first to eighth) of each device by using ↑, ↓, + and/or –.
To change the priority of a device, move the cursor to the device by using the ↑ or ↓, and
press + or –.
Device
USB CD-ROM drive
ATAPI CD-ROM (including optical disk drive)
USB floppy disk drive
USB flash memory device
IDE hard disk drives
Internal hard disk drives installed in your system ("Software RAID" is
displayed in the RAID configuration.)
IBA GE Slot xxxx
Onboard LAN.
LAN1: Slot 0C00, LAN2: Slot 0C01
Other indication
Optional PCI board connected to the riser card.
Configuring Your Server 4-25