NEC N8100-1429F User Manual page 277

Optional RAID Controller (N8103-116/117/118)
Your server can include the optional RAID Controller (N8103-116/117/118). The optional RAID
Controller can control the internal hard disk drives as the RAID System. To use the hard disk drives
in a RAID System, reconnect the hard disk drive interface cable on the mother board.
At the factory, the interface cable is connected to the SATA connector on the mother board.
Refer to the manual coming with optional RAID Controller (N8103-116/117/118) for details.
IMPORTANT:
static electricity. Make sure to touch the metal frame of the server to
discharge static electricity from your body before handling the RAID
Controller. Do not touch the RAID Controller terminals or on-board
parts by a bare hand or place the RAID Controller directly on the desk.
For static notes, see the section "Anti-static Measures" described earlier.
NOTE:
utility, select [Advanced] → [PCI Configuration], and confirm that
[Enabled] is set for the parameter [PCI Slot xx ROM] (xx: PCI slot
number).
Installation
See "PCI Board" in this chapter and manual that comes with the optional RAID Controller for the
installation of a RAID Controller (N8103-116/117/118).
IMPORTANT:
priority specified in BIOS SETUP utility must be eighth or younger. If
specified ninth or later, the configuration menu of RAID Controller will
fail to start.
Setting of Jumper Switch
To use the optional RAID Controller (N8103-116/117/118), you need to change jumper switch
setting on the backplane board.
Removal
Remove the optional RAID Controller in reverse order of the installation steps.
The RAID Controller board is extremely sensitive to
Before installing an optional RAID Controller, run the SETUP
When the RAID Controller is connected, the boot
Upgrading Your Server 9-29