Power Off - NEC N8100-1429F User Manual

Power Off

Follow the procedure below to power off the server. If the power cord of the server is connected to a
UPS, refer to the manual that comes with the UPS or the manual for the application that controls the
UPS.
IMPORTANT: Always allow POST to complete before turning off the
server.
1.
Shut down the OS.
2.
Press the POWER switch on the front of the server.
The POWER LED goes out.
3.
Power off peripheral devices.
Power-saving Mode
The server can be entered into standby state that hardly consumes electric power if the ACPI
compliant operating system is installed in your system.
Select "Standby" from OS shutdown menu, or press the POWER switch if the standby state is
enabled for POWER switch. (The POWER LED blinks.)
In the power-saving mode, the server retains the memory data and the status of the previous
operations.
To resume the original state, press the POWER switch again.
NOTE:
the OS in use. (Available for Windows Server 2003.)
IMPORTANT:
the power-saving mode or in the power-saving mode. Otherwise, you
may fail to resume the original state.
The operational level in the power-saving mode depends on
Do not change system configuration while turning into
General Description 2-19
POWER switch