NEC N8100-1429F User Manual page 261

1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Push the lever to unlock, and open the handle.
NOTE:
The POWER switch is located close to the hard disk drive bay.
Be careful not to press the POWER switch when installing or removing
the hard disk drive. Otherwise, the system shutdown will occur.
3.
Firmly hold the handle and hard disk drive, and pull out the hard disk drive.
4.
If using the server with the hard disk drive removed, install the dummy tray in the empty
slot.
5.
Power on the server. Run BIOS SETUP utility and set boot priority on the Boot menu.
Installing a hard disk drive clears boot priority that has been stored in SETUP.
6.
Install the front bezel.
Upgrading Your Server 9-13