NEC N8100-1429F User Manual page 302

D-8 Installing Windows Server 2003 x64 Editions
7.
Select the [Intel(R) ICH9 SATA AHCI Controller (Desktop/Server/Workstation)] and
press Enter.
Now the Setup goes back to Step 5.
– If the RAID controller is connected, press S to go on Step 8.
– If the RAID controller is not connected, press S to go on Step 9.
8.
Select the proper SCSI Adapter and press Enter.
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When N8103-116/117/118 RAID controller is used.)
– [LSI Embedded MegaRAID (Windows XP/2003 64-bit)]
(When LSI Embedded MegaRAID is used.)
9.
If you utilize N8103-75/107, press S.
A list of mass storage devices is displayed.
Select the [Adaptec Ultra320 SCSI Cards (Windows 64-bit)] and press Enter.
IMPORTANT:
N8103-75/107. Press S to proceed.
The driver you provided seems to be newer than the Windows
default driver.
Windows already has a driver that you can use for
"Adaptec Ultra 320 SCSI Cards (Windows 64-bit)"
Unless the device manufacturer prefer that you use the driver
on the floppy disk, you should use the driver in Windows.
10.
When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT:
the hard disk larger than 2,097,152MB (2TB), you can specify only a
value equal to or less than 2,097,152MB as partition size.
11.
When the installation of Windows Server 2003 x64 Edition has finished, the system
reboots automatically.
The following messages may be displayed when using
If you install Windows Server 2003 x64 Editions on