Table of Contents
Advertisement
User Manual
Cordless Phones for BusinessPhone™
•
To prevent the alarm from being sent and silencing the warning tone, do one of the
following:
- Press any key/button. The alarm will be reset.
- Put the handset in a charger. The alarm will be temporarily disabled indicated by
that the corresponding alarm icon is hidden. The alarm will be enabled when
removing it from the charger.
•
If no key/button is pressed during the warning tone, the alarm is sent. Depending on
set parameters, a beep/vibrator/LED signal confirms that the alarm has been sent.
See also
8.8.9 Alarm Settings
7.3
Acoustic Location Signal
Depending on set parameters, the ramped up ALS is played after an alarm. The signal
is always ramped from the lowest volume to the highest. Press
Depending on the PDM settings, it is possible to make the user enter a password when
turning the ALS off. The password is the same as the phone lock password.
ALS is configurable for Man-down & No-movement alarm, and Push-button alarm. See
the handset's Configuration Manual for more information.
7.4
Automatic Call after Alarm
A handset can be setup to call a pre-defined number after an alarm has been sent. It is
also possible to dial the number without sending an alarm by pressing a push-button
that is not configured with alarm functionality. Depending on the settings, the call can
be established in the following modes;
•
Loudspeaking mode
•
Normal mode
7.When Bluetooth is enabled, the loudspeaker audio is lowered due to current limitations in the intrinsically safe
handset.
AMT/PUD/TR/0119/1/2/EN 2012-08-13
on page 62.
7
, or
to turn the ALS off.
39
Advertisement
Table of Contents
