Alarm With Location Information; Alarm With Data; Acoustic Location Signal - Aastra DT4X3 User Manual

Cordless phones for mx-one
Hide thumbs Also See for DT4X3:
Table of Contents

Advertisement

User Manual
Cordless Phones for MX-ONE™
When an alarm is triggered, the following occurs;
A Man-down warning. Cancel? or No- movement warning. Cancel? dialog window is
shown in the display, and a warning tone is also signaling during a period (default 7 seconds)
before the alarm is sent.
To prevent the alarm from being sent and silencing the warning tone, do one of the
following:
- Press any key/button. The alarm will be reset.
- Put the handset in a charger. The alarm will be temporarily disabled indicated by that the
corresponding alarm icon is hidden. The alarm will be enabled when removing it from the
charger.
If no key/button is pressed during the warning tone, the alarm is sent. Depending on set
parameters, a beep/vibrator/LED signal confirms that the alarm has been sent.
Information about the handset's location may be sent along with the alarm, see
with Location Information
See also
8.8.9 Alarm Settings
7.3

Alarm with Location Information

Information about the handset's location can be sent along with an alarm. The location can be
added as follows;
An approximately location given by the closest Base Station (see the handset's
Configuration Manual) or,
Note: This function requires CPDM3
7.4
Alarm with Location Information
Information about the handset's location can be sent along with an alarm. The location can be
added as follows;
An approximately location given by the closest Base Station (see the handset's
Configuration Manual)
7.4.1

Alarm with Data

The data must manually be defined and stored by the user, see
recommended to add a shortcut for quick access to the "Edit alarm data" menu, see
Cuts
on page 60.
7.5

Acoustic Location Signal

Depending on set parameters, the ramped up ALS is played after an alarm. The signal is always
ramped from the lowest volume to the highest. Press
Depending on the PDM settings, it is possible to make the user enter a password when turning
the ALS off. The password is the same as the phone lock password.
ALS is configurable for Man-down & No-movement alarm, and Push-button alarm. See the
handset's Configuration Manual for more information.
1424-EN/LZT 103 089 A3 2012-02-23
on page 38.
on page 67.
7.3 Alarm
Edit Alarm Data
on page 62. It is
8.7 Short
to turn the ALS off.
38

Advertisement

Table of Contents
loading

Table of Contents