Safety Information; Environmental Note - Grundig CDM 800 User Manual

ENGLISH
C
2h
C
CDM-800 PORTABLE MICRO SYSTEM
STANDBY
DISPLAY
MEMORY REMOTE
CD tt STANDBY SENSOR
MODE/
TUNER /BAND TIMER PLAY/
PAUSE
TAPE
DSC STOP PLL SYNTHESIZER TUNER
+ t t
UBS
UBS
- ULTRA BASS SYSTEM
CD OPEN /CLOSE
CDM-800 PORTABLE MICRO SYSTEM
DISPLAY
Y STANDBY REMOTE SENSOR
tt
PLAY/
PAUSE
STOP PLL SYNTHESIZER TUNER
t
t
- UBS ULTRA BASS SYSTEM
CDM-800
PORTABLE MICRO SYSTEM
STANDBY
DISPLAY
MEMORY REMOTE
CD t STANDBY SENSOR
t
TUNER TIMER MODE/
/BAND PLAY/
PAUSE
TAPE DSC STOP
PLL SYNTHESIZER TUNER
t t
UBS +
UBS
- ULTRA BASS SYSTEM
CD OPEN
/CLOSE
CDM-800
PORTABLE MICRO SYSTEM
STANDBY
DISPLAY
MEMORY
STANDBY REMOTE SENSOR
CD t
t
TUNER MODE/ TIMER
/BAND PLAY/
PAUSE
TAPE STOP
DSC PLL SYNTHESIZER TUNER
t
t
UBS +
UBS ULTRA BASS SYSTEM
-
CD OPEN
/CLOSE
ANTENNA PHONES
22
SAFETY, INFORMATION
Safety
To ensure that this device provides you with long-term satisfaction and
enjoyment, please observe the following instructions:
This device is designed for the playback of audio signals.
Any other use is expressly prohibited.
Protect the device from moisture.
When deciding where to place the device, please note that furniture surfaces
are covered by various types of varnish and plastic, most of which contain
chemical additives. These additives can corrode the device supports, leaving
residues on the furniture surfaces which can be difficult or impossible to
remove.
Do not use any cleaning agent, as this may damage the casing. Clean the
device with a clean, moist leather cloth.
Never open the device casing. The manufacturer accepts no liability for
damage resulting from improper handling.

Environmental note

As little material as possible was used for packaging your device.
Three types of material were used: Cardboard (box), polystyrene and
polyethylene (bag).
Please observe the local regulations for disposing of the packing material.
Information
This device is noise-suppressed according to the applicable EC directives.
This product fulfils the European directives 89/336/EEC, 73/23/EEC and
93/68/EEC.
This device conforms to the safety regulation DIN EN 60065 (VDE 0860)
and therefore the international safety regulation IEC 60065.
Never open the device casing. The manufacturer accepts no liability for
damage resulting from improper handling.
The type plate is located on the bottom of the device.
Technical and optical modifications reserved!
_____________________