Tape Mode - Grundig CDM 800 User Manual

TAPE
FLAT I 4 : 3 0
CDM-800
PORTABLE MICRO SYSTEM
STANDBY
DISPLAY
MEMORY REMOTE
CD STANDBY SENSOR
t
t
MODE/
TUNER TIMER
/BAND PLAY/
PAUSE
TAPE
STOP
DSC
PLL SYNTHESIZER TUNER
t
t
UBS +
UBS
- ULTRA BASS SYSTEM
CD OPEN
/CLOSE
1

TAPE MODE

Note:
You can only play tapes using the buttons on the device.
Preparation
1 Press » STANDBY
2 Select TAPE as the input source using the » TAPE« button.
– Display: » TAPE« and time.
3 Open the tape compartment on the top right of the device.
4 Put a cassette in the compartment with the tape side facing upwards and
the full reel on the right.
5 Close the tape compartment.
6 Open the button cover panel.
Playback
1 Press » « to start playback.
– Playback stops at the end of the side of the tape currently playing.
2 Press » « to pause playback.
II
To resume playback, press »
3 To end playback, press » «.
Recording
Erase protection
Every new recording overwrites the existing recording on the tape.
You can protect your own cassettes against accidental erasure by breaking
the safety tabs on the top of the cassette.
Pre-recorded commercial music cassettes are already protected against
accidental erasure.
If you want to record on to a protected cassette, cover the opening with
adhesive tape.
Note:
Only use NORMAL-type cassettes (IEC
CHROME (IEC ) or METAL (IEC
II
The volume setting and the status of the » UBS« and » DSC« buttons
have no effect on the recording.
__________________________________________
« to switch on the device.
« again.
II
) for recording.
I
) tapes are not suitable.
IV
35