Table of Contents
Advertisement
4 Troubleshooting
How to perform a
hardware reset to
factory defaults
50
Problem
No Line synchronization achieved.
Line Sync LED keeps flashing
Proceed as follows:
Step
Put DIP switch number 4 in the UP position:
1
Console
Config
You will notice that the PWR/Alarm LED flashes amber.
Power cycle the SpeedTouch™610 and wait to allow it to restart.
2
The SpeedTouch™610 will come online with manufacturing defaults.
Reset the DIP switch in its original position. If not, the PWR/Alarm LED will
3
flash amber as a warning.
Note: Leaving the DIP switch in the UP position, will cause unintended reset
to manufacturing defaults !
A reset to factory default settings also deletes the configuration profile
4
settings. Therefore, a reconfiguration via the SpeedTouch™ Setup wizard or
via uploading the appropriate configuration file might be needed. See section
"1.3. SpeedTouch™610 Configuration Setup" on page 11
tion.
For more information on the operation and management of the SpeedTouch
the application note "SpeedTouch
Solution
Make sure DSL service (ADSL, SHDSL or
VDSL) is enabled on the wall outlet your
SpeedTouch™ is connected to.
Make sure the correct SpeedTouch™
variant is used for your DSL service
(ADSL, SHDSL or VDSL).
Action
TM
610 Operation and Management".
for more informa-
TM
610, see
3EC 37770 AAAA TCZZA Ed. 02
Advertisement
Table of Contents
