Alcatel SpeedTouch 610 Orientation Manual page 18

1 SpeedTouch™610 Installation
The configuration
procedure
14
Step
The setup wizard should find your SpeedTouch610 device on the local
6
network. This is indicated by following window:
If the wizard does not find a SpeedTouch610 on the network an error
window pops up. In this case check that:
•
Your PC is correctly wired to the SpeedTouch610
•
No dedicated firewall device or a router is placed between your PC and
the SpeedTouch610 and that no personal firewall software is running
on your PC
•
The SpeedTouch610 is powered on and fully initialized
•
TCP/IP is correctly installed on your PC, and that your PC is configured
with a valid IP address(*).
To retry the detection of the SpeedTouch610, click Back and repeat step 5
of this procedure.
(*) In case of MS Windows 95 or Windows NT4.0 it is advised to configure
the PC with a static IP address, e.g. 10.0.0.101, which is unique (in case of a
local network). Make sure however not to use the 10.0.0.138 IP address as it is
the SpeedTouch™610's default IP address. For MS Windows 98, 98SE, ME,
2000 and XP OSs it is advised to configure the PC as a DHCP client. Refer to
the MS Windows user documentation for more information.
To continue with the configuration of your SpeedTouch610 and your PC,
7
proceed with the configuration procedure described below
Step
As soon the wizard detected your SpeedTouch610 some device details are
1
shown. In case multiple SpeedTouch™ devices reside on your local LAN a
listing of devices is shown from which you can select the appropriate one.
Click Next to proceed.
Note: If the SpeedTouch610 has been configured before, it may be protected
by a System password. Before you are able to overview the device details or
continue with the configuration this password has to be entered.
Action
Action
3EC 37770 AAAA TCZZA Ed. 02