Table of Contents
Advertisement
2 The SpeedTouch™610 Web Interface
NAPT
28
•
Define one or more RIP neighbors in case multicast messages can not be sent or
received among the network
Do not forget to save your changes to persistent memory by clicking Save All.
For more information, see the application note "SpeedTouch™610 LAN Management".
Clicking this button pops up the Network Address and Port Translation (NAPT) page.
This page allows to:
•
Overview or add/delete specific static NAPT entries:
You can add static NAPT entries by clicking New. Specify the outside address and
inside address for the entry as well as the protocol and port on which the entry
applies. In case the NAPT entry should be applied on a dynamically assigned local
peer IP address of a connection, you should specify 0.0.0.0 as outside address.
Click Apply to add the entry to the table.
•
Define a default server:
By specifying a default server IP address (e.g. 10.0.0.1 as depicted above) all
incoming connections will be forwarded to the device with this IP address. In most
cases this setting should be adequate for most server applications and will make
the need for specific static NAPT entries redundant.
Do not forget to save your changes to persistent memory by clicking Save All.
For more information, see the application note "SpeedTouch™610 LAN Management".
3EC 37770 AAAA TCZZA Ed. 02
Advertisement
Table of Contents
