Normal Display; Ringer Volume; Select Ring - Alcatel-Lucent 8410D User Manual

To prevent the other party from hearing you (to mute the handset or speakerphone microphone)
1 Press <Mute>.
The red light next to <Mute> goes on, and the other party cannot hear you.
2 When you are ready to resume conversation with the other party, press <Mute> again.
The red light next to <Mute> goes off, and the other party can hear you again.
The Mute feature turns off automatically when you hang up, or switch from the speakerphone to the handset or from the
handset to the speakerphone.
To exit any display feature and return to normal display
1 Press <Exit>
Display will show call information for active call appearance
To adjust the ringer volume (speaker is not active)
1 To raise the volume, press the right half of the Volume control button. To lower the volume, press the left half of
the Volume control button.
The display shows the following:
RINGER L >>>>> H
One full ring cycle will sound to demonstrate the new volume.
There are eight possible volume settings. One arrow is the lowest setting, and eight arrows is the highest setting.
To select a personalized ring
1 While on-hook, press <Ring> (or <Shift> then <Hold> if you don't have a <Ring> button)
The red light next to <Ring> winks.
The current ringing pattern plays and repeats every three seconds
The ringing pattern you are hearing is displayed.
SELECT RING PATTERN: 1
2 Cycle through the ringing patterns by pressing (and then releasing) <Ring> (or <Hold>)
The red light next to <Ring> continues to wink.

Normal Display

Ringer Volume

Select Ring

19