Table of Contents
Advertisement
To place an AD call
1
Press the selected <AD xxxxx>.
The call is automatically dialed.
Note:
Before you can use this feature, AD buttons must first be assigned by your system manager.
A programmed number in your personal list can be up to 24 digits and characters. You can also program a number on
an Automatic Dialing button that is not stored in your personal list. This programmed number can be up to 16 digits
and characters. Each digit counts as one character; special characters, such as pause and suppress, count as two
characters. The Automatic Dialing button can be used for one-touch dialing of frequently called numbers.
To program or reprogram an outside number, extension, or feature code into a personal list
1
On a separate sheet of paper, write down the outside numbers, extensions, and/or feature access codes you want to
program as items on your personal lists(s).
Note:
Each telephone number or feature code is stored as a separate list item.
2
Pick up the handset.
3
Press <Menu> and then press the softkey below Prog.
or press <Program> or dial the Program Personal List code *01.
4
Dial the list item (0, 1, 2...).
5
Dial the number you want to store (up to 24 digits).
Note:
You may be able to use the softkeys to add special features such as Pause, Mark, or Wait into the
telephone numbers programmed on the AD button.
If you are programming an outside number, be sure to include a trunk code, if applicable.
6
Press <#>.
The number is stored.
7
Repeat Steps 5 through 7 if you want to program additional items.
9
Hang up or press <Drop> to end programming.
Note:
Keep a copy of your own personal lists.
To place a call using an AD list button or code
1
Press <Pers List>
or dial the Personal List feature access code *7
2
Dial the desired list item (0, 1, 2...).
[ringback tone]
[dial tone]
[dial tone]
[dial tone]
[confirmation tone]
[dial tone]
10
Hide quick links:
Advertisement
Table of Contents
