Connections; Cables Used For Connections; Connecting The Speakers; Connecting The Speakers Cables - Marantz PM-14S1 Owner's Manual

Connections

NOTE
• Disconnect this unit's power plug from the power outlet before connecting the speakers.
• Connect the speaker cables so they do not stick out of the speaker terminals. The protection
circuit may be activated if the wires touch the rear panel or if the + and – sides touch each
other (vpage 24 "Protection circuit").
• Never touch the speaker terminals while the power cord is connected. Doing so could result
in electric shock.
• Use speakers with an impedance of 4 – 8 Ω/ohms.

Cables used for connections

Provide necessary cables according to the devices you want to connect.
Speaker cable
Audio cable
Remote connector cable
L L
R R

Connecting the speakers

Connecting the speakers cables

Carefully check the left (L) and right (R) channels and + (red) and – (white) polarities on the
speakers being connected to the unit, and be sure to connect the channels and polarities
correctly.
1
Peel off about 10 mm of sheathing from the tip of the speaker
cable, then either twist the core wire tightly or apply solder
to it.
2
Turn the speaker terminal counterclockwise to loosen it.
3
Insert the speaker cable's core wire to all the way into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
Spade lug connector
ENGLISH
7