Table of Contents
Advertisement
Connections
n Contents
Connecting speakers
Connecting a playback device
Connecting a recording device
F.C.B.S. connection
Connecting a pre-amplifier
Connecting devices with remote control connectors
Connecting the power cord
NOTE
Do not plug in the power cord until all connections have
0
been completed.
Do not bundle power cords together with connection
0
cables. Doing so can result in humming or noise.
n Cables used for connections
Provide necessary cables according to the devices you
want to connect.
Speaker cable
.
Audio cable
L
R
.
Balance cable
L
R
.
Remote connector
cable
.
Connecting speakers
8
NOTE
10
Disconnect this unit's power plug from the power outlet
10
0
before connecting the speakers.
11
Connect so that the speaker cable core wires do not
0
15
protrude from the speaker terminal. The protection circuit
may be activated if the core wires touch the rear panel or if
16
the + and - sides touch each other. ("Protection
16
circuit" (v p. 27))
Never touch the speaker terminals while the power cord is
0
connected. Doing so could result in electric shock.
Use speakers with impedances within the ranges shown
0
below to suit how they are used.
Speaker terminals
No. of connected
used on this unit
speakers
SPEAKERS A
(Standard
2 (one set)
connection)
SPEAKERS B
2 (one set)
SPEAKERS A and
4 (two sets)
SPEAKERS B
SPEAKERS A and
SPEAKERS B
2 (one set)
(Bi-wiring
connection)
L
R
L
R
n Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to this unit, and be
sure to connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the
tip of the speaker cable, then either twist the core wire
tightly or terminate it.
2
Turn the speaker terminal counterclockwise to loosen it.
Speaker
Impedance
3
Insert the speaker cable's core wire to the hilt
into the speaker terminal.
4 – 16 Ω/ohms
4 – 16 Ω/ohms
8 – 16 Ω/ohms
4
Turn the speaker terminal clockwise to tighten it.
4 – 16 Ω/ohms
Spade lug connector
When using a banana plug
Tighten the speaker terminal firmly before inserting the banana plug.
ENGLISH
.
.
.
.
.
.
8
Advertisement
Table of Contents
