Connections; Connecting Speakers - Marantz PM10s1 Owner's Manual

Connections

n Contents

Connecting speakers

Connecting a playback device
Connecting a recording device
F.C.B.S. connection
Connecting a pre-amplifier
Connecting devices with remote control connectors
Connecting the power cord
NOTE
Do not plug in the power cord until all connections have
0
been completed.
Do not bundle power cords together with connection
0
cables. Doing so can result in humming or noise.
n Cables used for connections
Provide necessary cables according to the devices you
want to connect.
Speaker cable
Audio cable L
R
Balance cable
L
R
Remote connector
cable
Connecting speakers
8
10 NOTE
Disconnect this unit's power plug from the power outlet
10
0
before connecting the speakers.
11
Connect so that the speaker cable core wires do not
0
15 protrude from the speaker terminal. The protection circuit
may be activated if the core wires touch the rear panel or if
16
the + and - sides touch each other. ("Protection
16
circuit" (v p. 27))
Never touch the speaker terminals while the power cord is
0
connected. Doing so could result in electric shock.
Use speakers with impedances within the ranges shown
0
below to suit how they are used.
Speaker terminals No. of connected
used on this unit
SPEAKERS A
(Standard
2 (one set)
connection)
SPEAKERS B 2 (one set)
SPEAKERS A and
4 (two sets)
SPEAKERS B
SPEAKERS A and
SPEAKERS B
2 (one set)
(Bi-wiring
L connection)
R
L
R
n Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red)
and – (black) polarities on the speakers being connected to
this unit, and be sure to connect the channels and polarities
correctly.
1
2
Speaker
speakers Impedance
4 – 16 Ω/ohms
3
4 – 16 Ω/ohms
8 – 16 Ω/ohms
4 – 16 Ω/ohms
4
Peel off about 10 mm of sheathing from the tip of
the speaker cable, then either twist the core wire
tightly or terminate it.
Turn the speaker terminal counterclockwise to
loosen it.
Insert the speaker cable's core wire to the hilt
into the speaker terminal.
Turn the speaker terminal clockwise to tighten
it.
Spade lug connector
ENGLISH
8