Rear Panel - Marantz PM-14S1 Owner's Manual

Rear panel

Q0
q w e
SIGNAL GND (ground) terminal
q
Used to connect the earth wire of a turntable.
NOTE
This terminal is not a safety ground.
Audio input connectors (AUDIO IN)
w
Used to connect devices equipped with analog audio
connectors (vpage 8).
Input/output connectors (Recordings)
e
(RECORDER-1, RECORDER-2)
Used to connect to a recording device (vpage 9).
Speaker system terminals
r
(SPEAKER SYSTEMS)
Used to connect speakers (vpage 7).
REMOTE CONTROL connectors
t
Used to connect to a Marantz audio device that is compatible
with the remote control function (vpage 15).
o
r t y u
AMPLIFIER MODE switch
y
Used to switch the amplifier mode (STEREO/BI-AMP)
(vpage 11, 12).
F.C.B.S. connectors
u
Used to connect a high quality playback system using two
or more of these units (vpage 10).
AC inlet (AC IN)
i
Used to connect the power cord (vpage 15).
Power amplifier direct connectors
o
(POWER AMP DIRECT IN)
Used to connect a pre-amplifier when this unit is used as a
power amplifier (vpage 14).
PRE OUT connectors
Q0
Use this to add such equipment as a power amplifier or
subwoofer (vpage 14).
Part names and functions
i
ENGLISH
5