Fcc Information - Polycom VVX 500 Owner's Manual

FCC Information

This equipment complies with Part 68 of the FCC rules and the
requirements adopted by ACTA.
A FCC compliant telephone cord and modular plug is provided with this
equipment. This equipment is designed to be connected to the telephone
network or premises wiring using a compatible modular jack that is Part 68
compliant. See Installation Instructions for details.
The REN is used to determine the quantity of devices that may be
connected to the telephone line. Excessive RENs on the telephone line may
result in the devices not ringing in response to an incoming call. Typically,
the sum of RENs should not exceed five (5.0). To be certain of the number
of devices that may be connected to a line (as determined by the total
RENs) contact the local Telephone Company.
If this system causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service
may be required. But if advance notice isn't practical, the Telephone
Company will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is
necessary.
The Telephone Company may make changes to it's facilities, equipment,
operations or procedures that could affect the operation of the equipment. If
this happens the Telephone Company will provide advance notice so you
can make the necessary modifications to maintain uninterrupted service.
If the equipment is causing harm to the telephone network, the Telephone
Company may request that you disconnect the equipment until the problem
is resolved.
Connection to party line service is subject to state tariffs. (Contact the state
public utility commission, public service commission or corporation
commission for information.)
This equipment is hearing aid compatible.
Customer Owned Coin/Credit Card Phones
To comply with state tariffs, the Telephone Company must be given
notification prior to connection. In some states, the state public utility
commission, public service commission or corporation commission must
give prior approval of connection.
Data Equipment
The table below shows which jacks are associated with which modes of
operation:
Mode of Operation
Permissive
Systems
Facility Interface Codes (FIC), Service Order Codes (SOC), USOC Jack
Codes and Ringer Equivalence Numbers (REN) are shown in the table
below for each port where applicable:
USOC Jack
RJ11C
53
Owner's Manual