Extended Delay; No Delay-For Instant Alarm; Arming While A Door Or Window Is Open; Bypassing A Sensor Directly - GE Security CONCORD User Manual

10

Extended Delay

as much as 16 additional minutes to arm or disarm
the system before setting off an alarm.
Refer to the User Sheets to determine if there is an
Extended Delay for your delay door(s). If there is,
add that to the Entry and Exit Delay times to deter-
mine the actual delay times you have.
No Delay—For Instant Alarm
system is set to No Delay would immediately cause
an alarm.
No Delay is normally used:
• When you're staying at home, after you've armed
the system.
• When you're arming your house from the outside.
(You must have a wireless touchpad in order to
do this.)
Arming to Level 2 or 3 with No Delay, using a
touchpad:
1. Close all perimeter doors and windows.
2. Exit the premises if arming to 3—AWAY.
3. Enter:
2
The system sounds two or three short beeps.
4. Immediately after hearing the beeps,
press
On LED touchpads, No Delay lights.
Changing the arming level will restore delay doors
to their normal Exit and Entry Delay times.
In some situations, additional time is
needed to arm or disarm the system.
In these instances, the installer can pro-
gram an Extended Delay time, giving you
You can choose to turn off the Entry and
Exit Delays, causing the delay doors to
arm immediately. Anyone entering the
house through the delay door when the
CODE 3 CODE
+ or +
4
for No Delay.
2 3
1
STAY AWAY
6 7
5
ALARM -
Both Flashing
Enter Code
NO DELAY

Arming While a Door or Window is Open

REMEMBER:
When a sensor is bypassed, you are allowing
that door or window to go unprotected.
There are two methods for bypassing a sensor:
• Directly — After arming the system, bypass
door/window sensors before you open them.
You must know the sensor number of the door or
window you wish to bypass.
• Indirectly — As you are arming, bypass sensors on
already-open doors and window. This method
should not be used in UL-listed installations.

Bypassing a Sensor Directly

Use this method if the system is armed and you
would like to open a window without disarming.
Refer to the User Sheets in Appendix A to deter-
mine what the sensor number is for the door, win-
.
dow, or motion detector you wish to bypass.
To bypass sensors directly using an
alphanumeric or LED touchpad:*
1. Close all doors and windows.
2. Arm your system to the desired level.
Bypass Trouble 3. At any touchpad:
Check
Enter BYPASS +
Status
Power
• Alphanumeric touchpads display,
• On LED touchpads, the Bypass LED
It is possible to arm your system
while leaving a door or window
open. This is useful if, for example,
you like to sleep at night with the
window open.
If the door or window has a sensor
installed on it, the system must be
told to ignore, or bypass, that sensor
when it's open. All other sensors
will remain active.
CODE
+ sensor number.
"BYPASSED."
lights up:
2 3
1
STAY AWAY
6 7
5
ALARM -
Both Flashing
Enter Code
NO DELAY
Bypass Trouble
Check
Status
Power