Auxiliary Panic Alarm; Lighting During An Auxiliary Panic Alarm; Siren Time-Out; Assigning User Codes - GE Security CONCORD User Manual

14

Auxiliary Panic Alarm

The Auxiliary panic alarm sounds from interior
sirens only. It is typically set up by your security
dealer, based on your specific needs. On moni-
tored systems, the central station responds by call-
ing the service or agency you specified through
your dealer, such as an ambulance service.
To activate an Auxiliary panic alarm from a
touchpad:
• Press and hold the
for 2 seconds.
To send an Auxiliary panic alarm from a key-
chain touchpad:
• Press and hold the
buttons at the same time for 2 seconds.

Lighting During an Auxiliary Panic Alarm

If your system is equipped with system lighting, all
system lights will turn on and remain on during an
Auxiliary panic alarm.

Siren Time-out

If the system is not disarmed after an alarm, the
sirens will continue to sound until the time-out
period is reached. The time-out period can be
changed by the installer, but is usually 4 minutes.
Even though reaching the time-out stops the sirens,
the alarm will still be in progress and will remain so
until the system is manually disarmed.
S
A
The system requires a valid access code before it
will process most commands.
There is one System Master code which serves as
the primary User Programming code for your sys-
tem. Only a very limited number of users will need
to know this code.
There are two Partition Master codes (one for each
partition) which allow access to system operations
in their respective partitions.
AUXILIARY button(s)
There are 60 Regular User codes which act like
keys to arm and disarm the system. If necessary,
they can be assigned to neighbors, baby-sitters, or
repair persons for temporary use. Regular user
Lights and Star
codes can be changed in User Programming and
are easily deleted from the system when no longer
necessary.

Programming Access Codes

The code you use to enter User Programming deter-
mines which access codes you'll be able to change.
A user code can be given certain attributes which
limit what the user can do within the system. These
attributes can be changed only by a dealer over the
phone by using ITI downloading software.
The User Sheets in Appendix A provide a location
for you to record the actual user codes and the
attributes of each. If you would like any of the
attributes changed for any code, contact your
dealer.
6:
ECTION
U C
SSIGNING SER

Good Access Code Hygiene

To preserve the integrity of your
system, keep access codes
confidential and
delete extra codes
as soon as they
are no longer needed.
We recommend that you
avoid using obvious code
patterns such as 1234 or
1111, 2222, etc.
ODES