Phone Communication Test - GE Security CONCORD User Manual

34
Device
Supervised
wireless siren
Freeze sen-
sor
• If you need more time to complete testing, restart the timer by pressing 8 + CODE + 3.
• Check to see that all sensors have been tested by pressing
— Alphanumeric touchpads display a list of untested sensors.
— Untested sensor LEDs light on LED touchpads. Keep in mind that 8 sensors are represented.
• You'll know you've finished testing when:
— Alphanumeric touchpads display, "SENSOR TEST OK."
— When the Trouble light goes out on the LED touchpad.
3. Disarm to Level 1 to exit Test Mode.

Phone Communication Test

The purpose of this weekly test is to verify that the
connection between the central monitoring station
and your system are working properly.
Most phone tests take only a few minutes, however,
your system will try for up to 15 minutes to establish
a connection.
To perform a phone communication test:
1. Disarm the system.
2. Press
8
3. Press
• Alphanumeric touchpads display,
• LED touchpad sensor lights make a bounc-
4. If the phone test is successful:
• alphanumeric touchpads display,
• LED touchpads sensor lights stop bouncing
Within a few minutes, the display should return to
the Level 1 display. If it does not return in three
minutes, note how long before the Level 1 display
returns and contact the installer.
After the test has started, the arming level can be
changed to 1—Off, then to 2—Stay or 3—AWAY, if
you wish.
Test procedure
1. Unplug the siren and check the
alphanumeric touchpad display.
2. Plug the siren in.
Apply ice to the sensor.
Do not allow the sensor to get wet.
If over 8 sensors are installed in the system, the Trouble light will remain on until all sensors and
panic alarms are tested.
+ System or Partition Master
2
.
" PHONE TEST."
ing pattern from left to right.
"PHONE TEST OK."
pattern.
Alphanumeric: "SENSOR nn OK"
Alphanumeric: "SENSOR nn OK"
‚
CODE
.
Touchpad Result
LED: 1 beep; sensor LED goes out
LED: 1 beep; sensor LED goes out
: