Hanging The Fan; Wiring - Casablanca Antion C39G199L Owner's Manual

Step_5._ Slide the hanging adapter cover down over
the motor coupling as shown in Figure #5, making sure
that the adapter cover is covering the motor coupling
as in shown Figure #6.
CAUTION: The Motor Adapter has a special
coating on the threads. Do not remove this
coating; the coating prevents the downrod
from unscrewing. Once assembled, do not
remove the downrod.

HANGING THE FAN

Step_1._ Trim wires to about 6" from the top of the
downrod.
Step_2._ Strip 1/2" of insulation off each wire using
wire strippers. Raise the fan and place the ball into
the hanger bracket.
Step_3._ Align the notch on the ball with the indent
in the hanger bracket. (Rotate the fan until you hear
the notch pop into place.)
Fan may fall if
WARNING:_
not assembled as directed
in these installation
instructions.
10
FIGURE_5.
FIGURE_6.
Indention
Notch
WIRING HARDWARE
Receiver

WIRING

Step_1._ Locate the White Line Neutral (IN) and
connect it to the White Neutral Wire from your
ceiling using one of the supplied orange wire caps.
Step_2._ Connect the Black Line Power (IN) and the
Black Power Wire from your ceiling with an orange
wire cap.
Step_3._ Tuck the White and Black connected wires
back into the ceiling box through the hole in the
center of the Hanger Bracket while you slide the
Receiver into the open end of the Hanger Bracket as
shown.
NOTE: Ensure you do not tuck the bare ground
wire from the ceiling back into the box. This will be
connected later.
Step_4._ Connect the Blue Light Out Wire from the
Receiver to the Blue Wire coming from the fan with
a blue wire cap.
Step_5._ Take the White Neutral Out Wire and
connect it to the White Wire coming from the fan
with a blue wire cap.
a
™
ntion
Orange Wire Caps (3)
Blue Wire Caps (3)
Power_From_ Line_Power_
Ceiling
(IN)
Line_Neutral__
(IN)
White_
Neutral_From_
Ceiling
Tuck_Wires_
in_Box
Bare_Ground_
Wire
Blue_-Downlight_
Power
11